Massive Audio M8S Betriebsanweisung PDF herunterladen (Seite 18)

CONNECTIONS & SETUP

Control Out

The M8 features a 12VDC Control Out that can be used to sync

an external device with a 12VDC Control IN to M8 power ON/OFF

status. When the M8 turns ON (Manual, Audio Sense or Trigger)

the Control Out will output 12VDC. When the M8 turns OFF

(Manual, Audio Sense or Trigger) the Control Out will output

0VDC.

1. Using a 3.5mm mini cable, connect the M8 Control Out to

the Control IN on the device that is to synced to M8 power

status as shown in Diagram 17. POLARITY: TIP=+12VDC;

SLEEVE=GND.

2. Terminate the 3.5mm mini cable as appropriate for the

Control IN connection on the device being synced. Maintain

proper polarity.

CAUTION! Improper connection can cause damage to the

M8, the synced device or both. The Procient Warranty does

not cover this type of damage.

3. To test, with the M8 and synced devices connected to 110V

AC outlets, and with the Control IN/OUTs properly con-

nected, turn the M8 ON. The synced device should turn ON.

If not, conrm Control IN/OUT connections and polarit y. Use

a volt meter to conrm Control Out voltage at the M8 and

synced device. Turn the M8 OFF, the synced device should

turn OFF. (Some devices have an adjustable delay for Control

IN. Set as needed for the given device/application.)

AC Power Cord

1. After all connections have been made and conrmed, con-

nect the female IEC plug into the AC Input on the M8 Rear

Panel and then plug the AC power cord into an unswitched

110V AC outlet. Diagram 18

Power Mode Switch

set to ON, Auto or Trigger

3.5mm

Mini Plug

Cable

Black

To Trigger Device

Control OUT GND

White Stripe

To Trigger Device

Control OUT 3-30V AC/DC

M8 12VDC

Control OUT

Diagram 17 M8 12VDC Control Out Connections

Diagram 18 AC Power Cord Connections

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Massive Audio M8S Betriebsanweisung Seite 18

Kommentare zu diesen Handbüchern